Products For E-Beam

BTI is proud to introduce the Low Profile 768 pin Load Module.

This pogo pin interface is designed to be a 50 Ohm low profile interface suitable for IC packages up to 768 I/O pins and no more than 8 power supplies.

 

This system is designed to interface to your tester through 50 Ohm cables using a standard 0.1 x 0.1 inch pitch conductor to Ground configuration.

 

The top board is hermetically sealed to the Aluminium housing to guarantee a solid vacuum seal.

 

The low profile means that there is only one interface between the top cable board and the DUT card which will increase the signal clarity and band width without increasing the cost.

 

If you use the Schlumberger or Credence IDS5K, 10K, 10K+ or the 2K, give us a call or email us to get more information.

 

This interface is designed to fit in the standard chamber opening provided by the OEMs.

 

 

 

 

BTI is proud to introduce the Low Profile 256 pin Load Module.

This pogo pin interface is designed to be a 50 Ohm low profile interface suitable for IC packages up to 256 I/O pins and no more than 4 power supplies.

 

This system is designed to interface to your tester through 50 Ohm cables using a standard 0.1 x 0.1 inch pitch conductor to Ground configuration.

 

The top board is hermetically sealed to the Aluminium housing to guarantee a solid vacuum seal.

 

The low profile means that there is only one interface between the top cable board and the DUT card which will increase the signal clarity and band width without increasing the cost.

 

If you use the Schlumberger or Credence IDS5K, 10K, 10K+ or the 2K, give us a call or email us to get more information.

 

This interface is designed to fit in the standard chamber opening provided by the OEMs.

 

 

 

BTI Invoice #

Contact Us arrow

phone 480-539-4400

email sales@btipcb.com